4 mm Barbed Connector for Drip Irrigation Lines

Description

A small fitting for precision drip irrigation networks that joins 4 mm tubing to drippers or micro-sprinklers. Its barbed end grips the tube once it is pushed fully on, holding it in place so it neither slips off nor leaks during continuous operation. It is made of reinforced, UV-resistant plastic that stands up to sun and heat outdoors, and suits greenhouses, nurseries, tree and seedling irrigation, and low-flow systems. Before fitting, make sure the tubing is clean, free of cracks and the right size; afterwards, turn on the water to test the joint, and when removing it, pull the tube off carefully to avoid damage. It is not meant for high-pressure systems that are not designed for drip irrigation, and should be kept in a dry place out of direct sunlight until installed.